Real-time phase measurement and correction of dynamic multimode beam using a single spatial light modulator

In this Letter,a novel system for adaptively correcting the phase of a dynamic multimode beam is proposed.While using merely one spatial light modulator,the phase measurement of the first-order diffraction pattern and the correction of the zeroth diffraction order are simultaneously realized.The real-time experimental result is obtained at a control rate of 10 Hz.The power-in-the-bucket value is improved from 38.5%to 61.8%,even with fundamental mode content that is consistently below 30%.To the best of our knowledge,this is the first implementation of real-time adaptive correction of the entire multimode beam.     

Identifying anomalous Floquet edge modes via bulk-edge correspondence

Floquet engineering appears as a new protocol for designing topological states of matter,and features anomalous edge modes pinned at quasi-energy π/T with vanished topological index.We propose how to predict the anomalous edge modes via the bulk Hamiltonian in frequency space,and use Zak phase to quantitatively index the topological properties.The above methods are clarified by the example of time periodic Kitaev chain with chemical potential of harmonic driving and pulse driving,and topological phase transitions are manifested at different driving frequencies.     

双稳态结构中的1/2次谐波共振及其对隔振特性的影响

以典型的双稳态系统——屈曲梁结构为例,基于等效模型,结合解析、数值和实验手段,研究了双稳态结构中的1/2次谐波共振特性、演化过程、参数调节规律及其对隔振特性的影响.研究发现,当非线性刚度系数或激励幅值增加到一定程度时,系统会在一定带宽下产生显著的1/2次谐波共振;随着激励幅值增加,阻尼系统的1/2次谐波遵循“产生-增强-衰退-消失”的过程,该过程对峰值频率和峰值传递率有重要影响;适当提高非线性强度能有效改善双稳态结构隔振特性.针对双稳态屈曲梁结构开展的实验验证了1/2次谐波特性和隔振特性变化规律.     

浮升力和流动加速对超临界CO2管内流动传热影响

基于单相流体的概念,超临界流体的异常传热行为已经被研究很多年了,但是关于其流动传热机理仍没有统一的认识.本文通过理论分析和实验研究了超临界二氧化碳在竖直管内向上流动过程中,浮升力和流动加速效应对其流动结构和传热过程的影响.结果表明,没有确凿的实验证据表明超临界流体的异常传热行为是浮升力和流动加速直接导致的,存在的估计浮升力和流动加速效应准则均是在常物性流体的基础上,做了大量假设得出的,不同的研究者采用浮升力和流动加速准则分析超临界流体的传热恶化得出的结论不一致.最后,基于拟沸腾理论分析超临界流体的传热恶化过程,提出超临界沸腾数区分了超临界流体正常传热与恶化传热的转换边界,为超临界流体流动传热研究提供新思路,超临界沸腾数对建立用于不同技术的超临界流体动力循环的最佳运行条件具有重要意义.     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

An effective interference suppression algorithm for visible light communication system based on DBSCAN

In order to improve the signal-to-noise ratio and mitigate the damage of noise to the communication quality,an effective interference suppression algorithm,which is based on the improved density-based spatial clustering of applications with noise algorithms,is proposed for visible light communication systems using the complementary metal–oxide–semiconductor image sensor as the receiver.Experimental results show that the algorithm can learn the region where the payload data is located,filter out the noise data,and greatly decrease the interference.The effect of the algorithm is also studied through bit error ratio performance.     

平顶飞秒激光经圆锥透镜在熔融石英中成丝及超连续辐射

实验研究了平顶飞秒激光经圆锥透镜后在熔融石英中的成丝及超连续辐射.与高斯飞秒激光的成丝对比发现,平顶飞秒激光可以获得在圆锥透镜焦深区域内强度分布更为均匀的等离子体细丝,这一特征更有利于飞秒激光在固体介质中进行微纳加工等领域的应用.并且,在不损伤熔融石英的条件下,平顶飞秒激光成丝可以获得更高能量、更高转换效率的超连续辐射,这是因为若产生光强相近的细丝,平顶飞秒激光所需的初始激光能量更高,此激光能量下产生的细丝长度更长、均匀性更好.     

Simultaneous Removal of Antibiotics and Heavy Metals with Poly(Aspartic Acid)-Based Fenton Micromotors

The discharge of diverse pollutants has led to a complex water environment and posed a huge health threat to humans and animals. Self-propelled micromotors have recently attracted considerable attention for efficient water remediation due to their strong localized mass transfer effect. However, a single functionalized component is difficult to tackle with multiple contaminants and requires to combine different decontamination effects together. Here, we introduced a multifunctional micromotor to implement the adsorption and degradation roles simultaneously by integrating the poly(aspartic acid) (PASP) adsorbent with a MnO₂-based catalyst. The as-prepared micromotors are well propelled in contaminated waters by MnO₂ catalyzing hydrogen peroxide. In addition, the catalytic ramsdellite MnO₂(R-MnO₂) inner layer is decorated with Fe₂O₃ nanoparticles to improve their catalytic performance, contributing to an excellent degradation ability with 90% tetracycline (TC) removal in 50 minutes by enhanced Fenton-like reactions. Combining the attractive adsorption capability of poly (aspartic acid) (PASP), the composite micromotors offer an efficient removal of heavy metal ions in short time. Moreover, the designed micromotors are able to simultaneously remove antibiotic and heavy metals in mixed contaminants circumstance just in single treatment. This multifunctional micromotor with distinctive decontamination ability exhibits a promising prospective in treating multiple pollutants in the future.